DJI Phantom 3 - Activating the Phantom 3 Standard

This video will show you how to activate your Phantom 3. Toggle the S1 switch to the upper most
position and ensure both control sticks are centered. Slide the power switch to the right to turn on the
remote controller. Press the power button on the aircraft battery once then press and hold it again for 2
seconds to power on the aircraft. Go to your mobile device’s settings menu and select Wi-Fi. Select the
Phantom 3’s Wi-Fi network and enter the default password 12341234. If the password has changed
enter the new password. When the remote controller is connected to the Wi-Fi launch DJI Go. An
activation prompt will pop up. Tap next. Name your Phantom 3 Standard, you can change the name
later in the app if you so choose. Tap continue, then choose a stick mode. The default stick mode is
mode 2. You can set a customized mode under remote controller settings after activation. Tap continue
then select your desired measurement system and video standard. Tap continue. Next select whether or
not you’d like to use beginner mode. If this is your first time flying, practicing in beginner mode is highly
recommended. Confirm your account’s email address. Please note that the account you use to activate
your Phantom 3 Standard cannot be changed later. The aircraft’s information will be bound to your
account permanently. Your account will serve as proof of your warranty when you apply for service.
Disconnect your mobile device from the remote controller Wi-Fi network and connect to the internet.
Reenter DJI Go. Select activate and reconnect your mobile device to the remote controller Wi-Fi
network following the on screen instructions. Activation is now complete.