Spark, activating the aircraft by scanning the QR code. Connect the battery to the charger. Wake up the battery and fully charge it. Check and record the Wi-Fi SSID password in the battery compartment or on the storage box. Launch DJI Go 4. Log into your account. Tap the button on the upper right corner. Select san QR code. Scan the SN or QR code on the battery compartment. After scanning is successful turn on your aircraft. Connect your mobile device to the internet. Read the terms of use carefully. Select the rectangle as shown and tap I agree. Confirm your activation account. Tap activate. Disconnect your mobile device from the internet and connect it to the aircraft’s Wi-Fi. After activation is successful name your aircraft. Set the unit of parameter. Turn on beginner mode. If you are flying spark for the first time it is recommended not to turn off beginner mode for slight safety. Turn on enable advanced gesture control. Set a joystick mode, the default mode is mode 2.
DJI Quick Tips - Spark - Activating the Spark by Scanning the QR Code
Recent Articles
-
Resetting the Wi-Fi SSID and Password
DJI Osmo, restoring default Wi-Fi settings. Power on...
-
DJI Beginner Tutorial Videos - Spark - Mounting the Intelligent Flight Battery
This video will show you how to mount...
-
DJI Beginner Tutorial Videos - Spark - Key Components and Parameters
This video will introduce the main modules of...
-
DJI Spark - Controlling the Aircraft with the Remote Controller
This video will show you how to control...
-
DJI Quick Tips - Spark - Activating the Spark by Scanning the QR Code
Spark, activating the aircraft by scanning the QR...
