Phantom 3 Tutorials- How to install HDMI output module on Phantom 3 remote controller

This video will show you how to install the HDMI output module on the Phantom 3 remote controller in
a few easy steps. Before we get started make sure that you have the following tools and parts: remote
controller, HDMI output module, plastic cover, 3 Phillips head screws, 4 hexagon screws, Philips
screwdriver 3mm, Rocket Screwdriver 1.5mm. To install the new HDMI module you first need to remove
the original module from your remote controller. Please follow the steps: confirm that the remote
controller is powered off. Turn the remote controller upside down to expose the cover. Unscrew the 4
hex screws. Remove the cover. Unscrew the 3 Philips screws. Unclip 2 small wire clips. Unclip 1 large
wire clip. Pull out 3 black cables. Remove the original module. Insert the new HDMI output module.
Reconnect the 3 black cables and make sure they are tightly fitted. Screw in 3 Phillips screws. Reattach
the white cover. Screw in 4 hexagon screws.
The first part of the installation is now complete. To confirm that the HDMI module has been
successfully installed. Do as follows: power on the remote controller. Press the C1 and C2 buttons. If the
C1 and C2 buttons beep while pressed the HMDI output module has been successfully installed. The
module has 4 ports, the first is the USB port, the second port is currently not in use and has no
functionality as of today, the third is the testing part and the fourth is the HDMI type C output port. The
resolution of the video output is 720p. The output frequency can be set in the DJI Go app based on your
location: 50HZ (PAL) in most parts of Europe China and the Middle East and 60HZ (NTSC) in North and
South America and Japan.