This video will show you how to install and use the Osmo Vehicle Mount. The Vehicle Mount consists of 2 parts: the universal joint and the suction cap base. Tighten the nut on the ball joint and the mounting angle can be adjusted. Position the joint as desired and tighten the nut. Toggle the switch of the base to the lock position. Find a smooth surface on which to secure your mount. Ensure the suction cups and the surface are clean and without dust. Then stick the suction cups to the surface. Pull the lock on the suction cups after they’re attached to the surface. Screw the Osmo onto the Vehicle Mount’s rosette mount and tighten the lock ring. After adjusting to the desired angel tighten the nut on the ball joint. Please note: when travelling at speeds over 100km/hour or if your vehicle is accelerating quickly your Osmo will go into gimbal into protection mode. Also in low temperature conditions the grip of the suction cups will decrease. Make sure you’re using your vehicle mount responsibly and in the right situations.
OSMO Tutorials - How to install and use the OSMO Vehicle Mount
Recent Articles
-
Mounting the Zenmuse M1
Mount the Zenmuse M1. Rotate the gimbal. Lock...
-
Unlocking the Gimbal
DJI Osmo, unlocking the gimbal. Rotate the roll...
-
Locking an Osmo Gimbal
DJI Osmo, locking an Osmo gimbal. Rotate the...
-
OSMO Tutorials - How to install and use the OSMO Vehicle Mount
This video will show you how to install...
-
OSMO Tutorials - Osmo Battery and Charger Damage Assessment
This video will show you how to assess...
