Osmo Mobile Activation and Setup

This video will show you how to activate and setup your Osmo Mobile. To activate your Osmo Mobile first prepare the battery then activate the gimbal. Preparing the battery. Insert the battery into the Osmo Mobile can connect the power cable. The battery is charging if the system status LED slowly changes from light to dark and back to light again. The battery is fully charged when the system status LED turns green. The Osmo Mobile should only be powered on after the battery is fully charged. Otherwise the gimbal will not work. Activating the gimbal. Enable Bluetooth on your mobile device. Pull down and hold the power switch for 1.5 seconds then release the switch. The system status LED will blink green then turn solid green. This means the Osmo Mobile has been powered on successfully. Open the DJI Go app. DJI will automatically detect the Osmo Mobile. Connect to the device. DJI Go will display an activation prompt. Enter your DJI Go account to finish activation. Please note that a brand new Osmo Mobile should be connected to a Wi-Fi or mobile network for activation. Setting up the Osmo Mobile. With the Osmo Mobile powered off loosen the holder lock knob. Do not power on the Osmo Mobile without a mobile phone. If a mobile phone is not detected by the mobile phone detection sensor the Osmo Mobile will not work. Place your mobile phone in the holder and tighten the knob to secure its position. Use the adjustable arm to level your phone. If your phone tilts to the left pull out the adjustable arm. If your phone tilts to the right shift the phone to the left. Enable Bluetooth. Pull down and hold the power switch for 1.5 seconds then release the switch. The gimbal will center itself. Open the DJI Go app, click to connect the Osmo Mobile. The camera status LED will turn blue once it is connected to the Osmo Mobile. Enter the camera and you can start using your Osmo Mobile. If your mobile device has already been connected to the Osmo Mobile simply enter the DJI Go app to connect.